Parkside PDRP 6.2 A1 Originalbetriebsanleitung Seite 8

Safety instructions for pneumatic tools
present.Never work on materials
which are or could potentially be
highly flammable or explosive.
Only use the pneumatic cleaning
„ z
gun in well-ventilated areas.
For multiple hazards, please
„ z
ensure you have read and
understood the safety instruc-
tions before installing, operating,
repairing, maintaining or
replacing accessory parts, and
before working in the vicinity
of the pneumatic cleaning gun.
Failure to do so can result in
serious bodily injury.
Only qualified and trained
„ z
operators should set up, adjust
or use the pneumatic cleaning
gun.Do not modify the pneumatic
cleaning gun.Modifications can
reduce the effectiveness of safety
mechanisms and increase the
level of risk for the operator.
Do not discard the safety
„ z
instructions – give them to the
person operating the device.
Never use the pneumatic
„ z
cleaning gun if it is damaged.
The device must be regularly
„ z
maintained, so as to verify that
the required introduction/safety
instructions for pneumatic tools,
rated values and markings such
as rated speed or nominal air
pressure are affixed legibly to the
8 GB/IE/NI
device. The user must contact the
manufacturer to request replace-
ment labels or markings if this is
required.
Always use the device for the
„ z
specific applications for which it
has been designed!
Always operate the pneumatic
„ z
cleaning gun within the stated
pressure range (max. 6.2 bar).
Never connect the pneumatic
„ z
device to a compressed air hose
whose pressure is greater than
6.2 bar.
Never use hydrogen, oxygen,
„ z
carbon dioxide or any other bot-
tled gas as the source of energy
for this tool, since this may cause
an explosion and lead to serious
injury.
Maintain and clean the device
„ z
regularly as specified (see sec-
tion 'Care and cleaning').
Before setup or first use, check
the device for any damage.
Before use, always ensure that
the device is in perfect working
order.
Stay focused while working!
„ z
Unexpected movements of the
device can be hazardous.
Do not use any device if its
„ z
switches are faulty. A device that
can no longer be switched on
oroff is dangerous and must be