Using The Device; Care And Cleaning; Warranty And Service Information - Parkside PDRP 6.2 A1 Originalbetriebsanleitung

Operation / Warranty and service information
liquid into a fine spray.
Use compressed air that is clean, oil-free and dry
for the device. Ensure that you do not set the pres-
sure to a value higher than the maximum working
pressure for this device.

Using the device

z z
Remove any objects and debris from the sur-
† z
face to be cleaned.
5
Turn the valve to the vertical position to
† z
allow the addition of the liquid in the cleaning
4
liquid tank to the liquid-air mix. The valve
5
is continuously adjustable: depending on
the position of the valve
cleaning liquid will be mixed with the air.
Maintain a distance of around 1-3 cm from the
† z
surface to be cleaned
To start using the pneumatic cleaning gun,
† z
press and hold the trigger
For best results, move the brush
† z
in a smooth, circular motion over the surface to
be cleaned
Release the trigger
† z
your work.
After finishing your work, wipe down the sur-
† z
face with a dry cloth, switch off the compressor
and disconnect the compressed air hose from
the gun.
After finishing work, unscrew the cleaning
† z
4
liquid tank from the gun and dispose of the
contents in an environmentally-friendly manner.

Care and cleaning

z z
Maintenance must be performed by
properly trained personnel only.
Inspect the pneumatic cleaning gun at regular
intervals: there should be no cracks or damage
8
and the nozzle should be in perfect working
order.
Do not continue to use the pneumatic cleaning gun
12 GB/IE/NI
5
, more or less
3
.
7
repeatedly
3
when you have finished
if you notice any safety-relevant abnormalities. In
this case, please contact a specialist.
Cleaning the nozzle
5
Turn the valve to the horizontal position and
† z
3
press the trigger
with compressed air.
8
If the nozzle becomes heavily soiled,
† z
7
remove the brush
wise. Remove the nozzle
plain water.
General
Before each use, check to confirm that no
† z
liquid has condensed inside the compressed
air hoses.
When cleaning the pneumatic cleaning gun,
† z
use plain water — do not use aggressive
detergents. Turn the valve
position so that only air comes out of the gun
3
when the trigger
pneumatic cleaning gun and the brush in a
container filled with plain water. Press the
3
trigger to remove the dirt from the brush
7
and the nozzle
Empty the cleaning liquid tank
† z
use.
Store the pneumatic gun in a clean and dry
† z
place, and protect from frost.
After each use, wipe down the pneumatic gun
† z
with a clean, dry cloth.
WARRANTY AND SERVICE
INFORMATION
Warranty from Creative Marketing
Consulting GmbH
We give you a warranty on this device of 3 years
from the date of purchase. In the event of product
defects, you have legal rights against the retailer of
this product. Your statutory rights are not affected
in any way by our warranty conditions, which are
described below.
8
to clean the nozzle
by turning it anticlock-
8
and clean it with
5
to the horizontal
is pressed. Immerse the
8
.
4
after each