Sw Out Terminal - Sony SVT-S168P Bedienungsanleitung

1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "3" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The ALARM SET menu appears.
ALARM SET
ALARM MODE
ALARM SPEED
ALARM DURATION
ALARM DATA REC
TAPE END WARN.
CLOG DETECTION
SERIES REC
< >
NEXT PUSH
+ –
SELECT : DATA SET : /
4
Press MENU V to move the flashing to the setting
of TAPE END WARN. and set to COUNTER or
TAPE END by pressing MENU + or –.
ALARM SET
ALARM MODE
ALARM SPEED
ALARM DURATION
ALARM DATA REC
TAPE END WARN.
CLOG DETECTION
SERIES REC
< >
NEXT PUSH
+ –
SELECT : DATA SET : / RETURN : MENU
COUNTER: the time counter shows "3:00:00",
then signal is output from the TAPE END OUT
terminal (recording will be continued to the end
of the tape).
TAPE END: the VCR detects the tape end.
5
Press SEARCH/AUDIO ON to return to the
normal display.
A1
3H
20s
OFF
COUNTER
ON
OFF
RETURN : MENU
A1
3H
20s
OFF
COUNTER
ON
OFF

SW OUT Terminal

The VCR outputs a pulse signal from the SW (switch)
OUT terminal to the camera switcher to control the
switching from camera to camera.
SW OUT terminal
Specify the interval between each pulse signal on the
DISPLAY SET/BUZZER/SW OUT menu. Also, set
MODE to FIELD or FRAME depending on the
specifications of the camera switcher.
Available settings are:
• FIELD: 1, 2, 3, 4, 5, 10, 30, or 60 fields
• FRAME: 1, 2, 3, 4, 5, 10, 30, or 60 frames
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "2" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The DISPLAY SET/BUZZER/SW OUT menu
appears.
DISPLAY SET DATE
TIME
SPEED
ALARM
WARNING
BUZZER ALARM IN
TAPE END
KEY IN
SW OUT MODE
TIMING
3H MODE
<NEXT PUSH >
+ –
SELECT : DATA SET : / RETURN : MENU
COM terminal
ON
ON
ON
ON
ON
ON
ON
OFF
FIELD
0 1
ON
(continued)
45
(GB)