Recording; Displaying The Real Time (In Recording Or Stop Mode Only) - Sony SVT-S168P Bedienungsanleitung

Recording

This section shows you how to record the signal from
the video camera in the normal or time lapse mode, to
set the security lock, to record repeatedly on the same
cassette and series recording.
1 2
1
Turn on the power of the equipment to be used.
2
Insert the cassette.
3
Set the recording speed by pressing REC/PLAY
SPEED + or –.
Recording Maximum recording
speed (h) time with 180-minute
tape (h)
3 Standard 3
mode
12 15
24 27
48 51
Time
lapse
72 75
mode*
96 99
120 123
168 171
* In time lapse mode, you can record an additional 3 hours
longer than the displayed recording time.
In the display window
STOP
3 4
x
PAUSE X
Interval Audio Tape
(sec.) recording motion
1/50
0.1 Possible Continuous
0.18
0.34
0.5
0.66 No Intemittent
0.82
1.14
Recording speed
4
Press REC z.
Recording starts.
To stop recording
Press STOP x.
To pause recording
Press PAUSE X.
To resume recording, press the button again. If pause
continues for more than 5 minutes, the VCR
automatically stops.
If recording does not start and the cassette is
ejected
The tab on the cassette is removed to protect against
accidental recording. Use a cassette with its safety tab
or cover the safety tab hole with a piece of plastic tape.
Displaying the real time (in recording or stop
mode only)
Set the COUNTER/REAL TIME switch to REAL
TIME. The real time will be displayed in the display
window. In playback mode, the display shows the tape
counter regardless of the switch position.
Notes
• Whenever you insert a tape and first start recording,
Adaptive Picture Control (APC) automatically improves
recording quality by adjusting the VCR to the condition of
the video heads and tape. To activate this function, set
APC in the GENERAL SET menu to ON (see page 39
(GB)). There is about a 10-second delay before the VCR
actually starts recording when REC z is pressed. ("APC"
appears in the display window and on the monitor screen.)
• This VCR is provided with a clog detection function. In
time lapse mode, if recording is not made properly, and a
warning signal will be output from the WARNING OUT
terminal. In this case, stop recording immediately and
check the VCR.
• If ALARM DATA REC in the ALARM SET menu and/or
TAPE USED COUNT in the GENERAL SET menu is set
to ON, the VCR will rewind the tape and recording will
start from the beginning of the tape. While the VCR is
rewinding the tape, "<ALARM DATA REC>" and/or
"<TAPE USED COUNT>" appears on the monitor screen.
• While both TAPE USED COUNT and ALARM DATA
list are being recorded, the REC indicator in the display
window lights up (in this case, the REC indicator goes out
momentarily between TAPE USED COUNT and ALARM
DATA list).
• When the main head clogs up during recording, it is
replaced automatically by the sub head and the recording
continues. In this case, the SUB indicator will light on the
display window.
19
(GB)