Selecting A Location; Fitting The Drive Elements; Mud Guards - Truma Mover Te R4 Gebrauchsanweisung, Einbauanweisung

5. Short mounting system
Replacement for standard mounting system if this cannot be
used due to lack of space and to compensate for the height
(30 or 60 mm) of substructures such as tanks.
Part. no. 60031-20000
Figure 13
6. Mud guard set (no illustration)
Replacement for the standard mud guards, if these cannot be
adapted to the Mover®.
Part. no. 60031-08200
Detailed installation instructions are included with each
mounting set.
The Mover® TE R4 must not be fitted to caravans /
trailers with other frames!
The vehicle frame must not be drilled (except when using the
low chassis kit) or welded. Wheel suspension parts must not
be removed under any circumstances.

Selecting a location

The Mover® is installed in front of the first axle and behind the
second axle. Only use the bolts provided (or the mounting
parts available as special accessories) to attach the Mover®.

Fitting the drive elements

The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions,
Remove all components from packing and place on the floor.
Figure 14
22

Mud guards

When a Mover® is fitted, the existing mud guards must be
moved / adapted if necessary (max. distance between tyre /
mud guard 300 mm).
If the original mud guards cannot be used, the Truma mud
guard set (part no. 60031-08200) must be used and adapted.
The mud guards are installed behind the axle. No mud
guards are required in front of the axle.
Mover® TE R4
Driving direction
Figure 15
Adapting the mud guards to the Mover®
1. Remove the mud guards.
2. Fit Mover® in accordance with the following installation
instructions.
3. Determine the dimensions a and b and transfer them to the
mud guards. The top leg of the fastening bracket must face
towards the rear of the caravan.
Determining the cut-out sizes
Mover® TE R4
a
b
Figure 16
Cut out the template on the last page of the installation in-
structions, place it onto the mud guard, transfer the contours
and cut out.
Pay attention to left and right sides!
If necessary, make recesses in mud guard for apron contour
and attach mud guard to underside of caravan 300 mm from
tyre.
In order to guarantee the validity of the general operat-
ing permit (ABE), the 4 data plates (f) provided must be
mounted on the left and right of the cross-strut between the
holding sheets for the drive assemblies.
Figure 17
max.
300 mm
max. 200 mm
a
b
f