Tuning The Electronic Control Unit To The Radio Remote Control; Technical Data; Declaration Of Conformity - Truma Mover Te R4 Gebrauchsanweisung, Einbauanweisung

Tuning the electronic control unit to the radio
remote control
The remote control and the control unit (master) are
tuned to each other in the factory.
If the control unit or the remote control is replaced, they must
be tuned to each other again in accordance with the instruc-
tions below.
Check that installation has been carried out in accordance
with the installation instructions, and make sure that the drive
rollers are not engaged. Check that the battery is properly
connected and in good condition, and that the control unit is
being supplied with 12 V. Make sure that the caravan con-
nector is plugged into the safety socket.
Press and hold the reset button (k) on the control unit (red LED
– j – flashes slowly), and after approx. 5 sec the LED (j) flashes
rapidly. Release the reset button and within 10 sec press and
hold the button (c) – caravan reverse – on the remote control,
at the same time switching on the remote control using the
slide switch (a).
j
k
Figure 5
The remote control and the control unit are now tuned to each
other. Once tuning is complete, the red LED flashes fast.

Technical data

Operating voltage
12 V DC
Power consumption
On average approx. 65 A up to a maximum of 150 A
Quiescent current consumption
< 2 mA
Radio frequency
Class 1, 868 MHz
Speed
Approx. 17 cm per second (depending on weight and slope)
Weight
Approx. 66 kg
Engagement motors fuse
Flat fuse 20 A
Positive line fuse
150 A
Use of the Mover® TE R4
Twin-axle caravans with a gross weight of up to 3000 kg
Subject to technical changes.

Declaration of conformity

1. Information about the manufacturer
Name:
Address:
2. Device identification
Type / model:
Manoeuvring assistant Mover® TE R4
3. Complies with the requirements of the following EC
directives
3.1 R&TTE directive (1999/5/EC)
3.2 EMC directive (2004/108/EC)
3.3 Radio interference suppression in motor vehicles 72/245/EEC
(with supplements)
3.4 Low Voltage Directive (2006/95/EC)
3.5 End-of-life vehicle directive (2000/53/EC)
and bears the type approval number e1 03 4473
and the CE mark.
Mover® SE R / TE R:
Class 1, frequency 868 MHz.
a
Countries:
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU,
IE, IS, IT, LT, LU, LV, MT, NL, NO, PL, PT, RO, SE, SI, SK.
c
4. Basis of the proof of conformity
EN300220-2:2006, EN300220-1:2006 (R&TTE art. 3.2),
EN301489-1:2005, EN301489-3:2002 (EMC art. 3.1b),
EN61000-4-2:2001, EN61000-4-3:2006, EN61000-4-6:2001,
EN55022:2003 (Class B), ISO 7637-2:2004, EN60950:2001,
2004/104/EC, 2005/83/EC, 2006/28/EC, 2000/53/EC
5. Monitoring body
Federal Motor Transport Authority (Kraftfahrt-Bundesamt)
6. Signatory details
Signature: Mathias Venschott
Product Centre Manager
Air Conditioning and
Manoeuvring Systems
Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Str. 12, D-85640 Putzbrunn
Putzbrunn, 22.04.2013
19