Minimum Installation Dimensions; Measuring The Frame Height; Determining The Installation Type; Special Accessory Installation - Truma Mover Te R4 Gebrauchsanweisung, Einbauanweisung

Minimum installation dimensions

A distinction is made between L-profile and U-profile
frames as shown in the illustration.
Caravan floor
L-profile
Figure 6
Installation is only possible on caravans / trailers with the fol-
lowing dimensions.
Caravan floor
170
min. 25
min. 35 **
min. 50 / max. 180
min. 1200 / max. 2000
Figure 7
All dimensions in mm.
* with loaded vehicle with max. permissible gross weight
** with U-profile

Measuring the frame height

A frame height of at least 170 mm is required at the level of
the tyre hub / tyre centre in the range of 340 mm from the
outer edge of the tyre.
min. 170
340 Driving direction
Figure 8

Determining the installation type

1. Standard installation
Standard installation is used with a U-profile or L-profile chas-
sis and a frame height of at least 170 mm. No special access-
ories are required.
2. Installation on chassis with U-profile or L-profile
and a frame height of between 110 mm and less than
170 mm
In order to compensate for height, the 30 mm spacer set
(for frame heights down to 140 mm) or the 60 mm spacer
set (for frame heights of less than 140 mm) is required.
3. Installation on chassis with U-profiles or L-profiles
with a frame height of less than 110 mm
If the chassis has a frame height of less than 110 mm, a low
chassis kit must be fitted to compensate for the height.
If a low chassis kit is used in Germany, accept-
ance by a vehicle expert is required.
U-profile
min. 170
340

Special accessory installation

1. 30 mm spacer set
For compensating for height on caravans / trailers with a
frame height of < 170 mm down to 140 mm,
part no. 60030-95000.
Figure 9
2. 60 mm spacer set
For compensating for height on caravans / trailers with a
frame height of < 140 mm down to 110 mm,
part no. 60030-95100.
Figure 10
3. Low chassis kit
For compensating for height on caravans / trailers with a
frame height of less than 110 mm and / or for bridging struts,
part no. 60010-64900.
Figure 11
If this installation kit is used in Germany, acceptance
by a vehicle expert is required.
4. Low chassis kit, short
For compensating for height on caravans / trailers with a
frame height of less than 110 mm,
part no. 60030-37600.
Figure 12
If this installation kit is used in Germany, acceptance
by a vehicle expert is required.
21