Inhaltsverzeichnis
Werbung
2.
While the system is securely resting on the sawhorse.
Install triangle plates (37) to top pole section (4) using bolt (40) and nut (31) as shown.
TEST-FIT LARGE BOLTS INTO LARGE HOLES OF
ELEVATOR TUBES, BACKBOARD BRACKETS,
AND TRIANGLE PLATES.
CAREFULLY ROCK THEM IN A CIRCULAR
MOTION TO REAM OUT ANY EXCESS PAINT
FROM HOLES IF NECESSARY.
NOTE
TIGHTEN BOLT (29) IN LOCK NUT (31) UNTIL
FLUSH (EVEN) WITH LOCK NUT'S OUTER EDGE.
4
WARNING!
TWO PEOPLE REQUIRED FOR THIS
PROCEDURE. FAILURE TO FOLLOW THIS
WARNING COULD RESULT IN SERIOUS INJURY
AND/OR PROPERTY DAMAGE.
WARNING!
37
37
31
21
40
Werbung
Inhaltsverzeichnis
