Indefinite Time Cycle With Cabinet Set Point Setting; Conservation Phase; Storing An Executed Blast Chilling / Freezing Programme; Recall Of Memorised Blast Chill/Shock Freeze Programme - Nordcap Project Line Gebrauchs- Und Wartungshandbuch

7.3.6. INDEfINITE TIME CYCLE WITH CAbINET SET POINT SETTING

Press the
cate the letters PO and the clock symbol
Select a blast chill or shock freeze programme with the appropriate buttons +3°C soft
(Fig.13)
soft
the type of blast chill
DISPLAY 2 indicates the default temperature of the selected cycle for blast chill (Fig.14).
(Fig.14)
Pressing the button
in DISPLAY 2. To start or stop the machine press the

7.3.7. CONSERVATION PHASE

The machine proceeds to conservation phase when the last core probe has reached core temperature
at the end of the cycle. DISPLAY 2 indicates the cabinet temperature (Fig.15).
The conservation symbol
(Fig.15)
Pressing the button
phase. This phase is terminated by pressing the
The machine sets itself on Stand-by and the user is asked whether the programme is to be memo-
rised or the button must be pressed once more. Press the core probe heating button
extraction of the probe from the product (after shock freezing).
The
Core probe heating takes place only if the temperature of the probe is less than -5ºC

7.3.8. STORING AN EXECuTED bLAST CHILLING / fREEZING PROGRAMME

Press the
of the first free programme. When the
trol positions itself to re-start with a new cycle (Fig.16).
It is possible to cancel a memorised programme by overwriting it with a new blast chill/shock freeze
(Fig.16)
cycle as follows: instead of memorising a completed cycle on the first free programme automati
cally selected by the system, pressing the button
the programme to be cancelled and press the programme button
If symbols
memorised programmes.
(Fig.17)

7.3.9. RECALL Of MEMORISED bLAST CHILL/SHOCk fREEZE PROGRAMME

To select a stored programme, press the button
the stored programmes in succession (Fig.18). Press button
selected blast chill/shock freeze programme. If DISPLAY 2 (Fig.17) indicates symbols
(Fig.18)
there are no memorised programmes.
button to exit any programme. Press the button once again and DISPLAY 1 will indi-
. DISPLAY 1 indicates the infinity symbol
or shock freeze
and
light up.
and
symbol lights up on the display.
button when the machine is in conservation mode. DISPLAY 1 indicates the number
appear on DISPLAY 2 (Fig.17), it means that there are no
(Fig.13).
, the temperature symbol
to increase or decrease the set temperature value shown
to view the time elapsed from the beginning of the conservation
, button (cap.7.3.8).
, button is pressed, the cycle is memorised and the con-
and
, and then the buttons
with the clock symbol
and
button.
position it on the number of
.
, to commence the
EN - 29
or –18°C
, next to it,
.
to facilitate
.
and to display