Description Of Controls - Angelo Po 0G0FA0 Bedien- Und Installationshandbuch

DESCRIPTION OF CONTROLS

The appliance is fitted with
the controls for use of its
main functions.
A)Top burner control knob:
turns on and off and regu-
lates the corresponding
top burner
SWITCHING THE TOP BURNER ON AND OFF
Lighting
1 - Turn on the gas supply tap.
2 - Press the knob (A) and turn it anti-clock-
wise (pos. 1) to light the pilot light.
3 - Keep the knob pressed for about 15 sec.
to prime the thermocouple.
4 - Turn the knob anti-clockwise (pos. 2) to light the
burner.
5 - Turn the knob gradually anti-clockwise to adjust
IT
the power of the flame down to the minimum
setting.
GB
Turning off
1 - Turn the knob clockwise (pos. 3) to turn the
DE
burner off.
2 - The pilot light will remain on to allow the burner
to be re-lit.
FR
3 - Turn the knob clockwise (pos. 4) to turn off the
pilot light.
ES
4 - Turn off the knob to ensure safety.
LENGTHY DOWNTIMES OF APPLIANCE
If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Turn off the gas supply tap.
2 - Clean the appliance and the surrounding areas
thoroughly.
English
Rear burner
Off marker
A
Minimum power
marker
- 8 -
Front burner
marker
A
Full power
marker
A
A
3 - Spread a film of edible oil over the stainless
steel surfaces.
4 - Carry out all the servicing procedures.
5 - Cover the appliance and leave a few gaps to al-
low air to circulate.
marker
Pilot light
marker
A
IDM-39614500600.tif
1
2
3
4
IDM-39614500800.tif