Power Alarm Configuration; Ip Configuration - Eks e-light 2M Bedienungsanleitung

Power alarm configuration

The power alarm configuration activates the relay contact. Without activating the
power alarm function the relay alarm will not work.

Tick the box if you want to monitor the power supply and then click

IP Configuration

You can configure the IP settings and the DHCP client function:

DHCP Client: Activating and deactivating the DHCP client function: When the
DHCP client function is active, the DHCP network server assigns an IP
address to the switch. After having clicked on "Apply" , a pop-up will open.
This pop-up shows that the DHCP client is activated. The current IP is then
substituted by a new one. To cancel the DHCP client function, please click
"Cancel".

IP Address: Enter the IP address of the network. When the DHCP function is
activated, you do not need to enter the IP address. The DHCP network server
determines the IP address of the switch and shows it in the corresponding
column. The default IP is 192.168.10.1.
Bedienungsanleitung
Manual
Power Alarm Interface
MAN_EL-2M
Version: 2.8 / 15.09.2017
Freigabe: P.S.
Seite 42 von 69
Apply