Hardware Installation; Procedure - Eks e-light 2M Bedienungsanleitung

Hardware Installation

This paragraph describes how to install the e-light 2M switch:

Procedure:

1. Unpack the switch.
2. Switch the device on. Tips regarding wiring can be found in the paragraph
wiring the power supply. The power LED lights up. Its meaning can be found
in the paragraph LED indications.
3. Prepare the twisted-pair cable (category 5) for the Ethernet connection. .
4. Put one end of the RJ45 cable into the Ethernet port (RJ45) of the switch and
the other end into the Ethernet port of the network device, e.g. the switch, a
PC or a server. The RJ45 port LED lights up when the cable is connected to
the network device. The meaning of the LED signals can be found in the
paragraph LED indications.
5. When all connections are established and the LEDs are flashing
corresponingly, the installation has been completed properly.
Bedienungsanleitung
Manual
MAN_EL-2M
Version: 2.8 / 15.09.2017
Freigabe: P.S.
Seite 19 von 69