Replacing Side Brushes; Cleaning - Kärcher B 300 RI D Handbuch

9.7

Replacing side brushes

9.8

Cleaning

DANGER
Risk of injury!
Remove the ignition key prior to performing any clean-

ing and maintenance tasks!
9.8.1 Cleaning/replacing dust filter cartridges
72
1 Side brushes
2 Screws
Loosen 4 screws and remove the side brushes.

Insert new side brushes and fasten with four screws.

9.7.1 Converting the side deck
The conversion to the side scrubbing deck or side

brushes deck must be accomplished by Customer Ser-
vice; the sweeping level and the cleaning parameters
must be reset after the conversion.
Park the vehicle on a level surface.

Turn ignition key to "STOP" and remove it.

Activate parking brake.

CAUTION
Health hazard!
Wear a dust mask when working around the dust filter.

Observe safety regulations on the handling of fine par-
ticles.
Wear an eye shield!

ATTENTION
Do not use any hard objects for cleaning!
The dust filter cartridges are responsible for filtering and
retaining the dust suctioned up by the suction turbine dur-
ing sweeping.
Dedust the dust filter with the filter dedusting switch
–
each day during and after cleaning (see Chapter
"Cleaning | Dedusting the dust filter".
Remove and clean the dust filer from time to time.
–
Complete replacement every 1500 operating hours!
–
1 Suction blower cover
2 Handle
3 Screw
Open the screw and tilt the suction blower cover to-

wards the rear.
31
-
EN