Fill In Motor Oil - Kärcher B 300 RI D Handbuch

9.5.2 Secure raised waste container
9.5.3 Check engine oil level and top up, if required
DANGER
Risk of injury!
Always apply the safety rod when the waste container

is raised.
Perform the safeguarding only from outside the hazard

zone.
1 Waste container
2 Safety rod
Lift the waste container and secure by means of cylin-

der support.
After maintenance work, pull the cylinder supports back

out again and fold at the top into the retainer.
1 Oil dipstick
2 Oil filler cap
Park the vehicle on a level surface.

Pull out oil dipstick.

Wipe off oil dipstick and insert.

Pull out oil dipstick.

9.5.3.1 Check the motor oil level
Read the value of the oil level.

Insert the oil dip again.

The oil level must lie between "MIN" and "MAX" mark-
–
ing.
Add motor oil if the oil level is below the "MIN" marking.
–
9.5.3.2

Fill in motor oil

ATTENTION
An oil level that is too high leads to damages of the engine
by overheating. If the oil level exceeds the "MAX" mark, oil
must be drained until the correct oil fill level has been
reached.
Remove the oil filler cap.

Fill in motor oil.

Oil grade: Refer to chapter "Technical data"
Do not fill oil above the "MAX" marking.

Close oil cap.

Wait at least 5 minutes.

Check engine oil level.

26
-
EN 67