Charging Battery - Kärcher B 300 RI D Handbuch

9.3.3 Installing and connecting the battery
9.3.4

Charging battery

Danger
Risk of injury! Comply with safety regulations on the han-
dling of batteries. Observe the directions provided by the
manufacturer of the charger.
Danger
Charge the battery only with an appropriate charger.
ATTENTION
The battery must only be loaded by a qualified operator.
ATTENTION
When the battery is charged, first remove the charger from
the mains and then disconnect it from the battery.
Disconnect the connecting cable from the battery at the

positive terminal.
Charger connect to battery.

Plug in mains connector and switch on charger.

Charge battery using lowest possible level of charging

current.
ATTENTION
The battery must only be installed and removed by a qual-
ified operator.
1 Support
2 Angle bracket
3 Battery
4 Seat contact switch
5 Cover with driver seat
Tilt the cover upwards and secure it with the support.

Insert battery in battery mount.

Attach the battery by means of an angle bracket.

Connect pole terminal (red cable) to positive pole (+).

Connect the pole terminal (black cable) to the negative

terminal (-).
ATTENTION
Before removing the battery, make sure that the negative
pole lead is disconnected. Check that the battery pole and
pole terminals are adequately protected with pole grease.
24
-
EN 65