NEC MultiSync FE700 Serviceanleitung Seite 69

3-2. OSM Menu
This unit is adjusted in on-screen menu by front panel key operation.
There are two types of menu.
(1) Menu (user):
(2) Menu (factory):
Hereafter, they will be called MENU (U) and MENU (F).
The menu can be displayed when the signal is input to the display unit.
3-3. Factory Mode
This unit has the MCU function called "Factory Mode".
Factory Mode:
User Mode:
Set the factory mode to the ON condition before adjustment.
Set the factory mode to OFF (User Mode) after completing adjustment.
3-4. Factory Mode Setting
3-4-1. Enter Factory Mode
(1) Open Menu (U),TAG 7 "DISPLAY MODE" and push "PROCEED".
(2) Push and hold "RESET" SW and push "▼" SW at the same time.
(3) A "WARNING" will be displayed, then push "PROCEED" SW once.
(4) OSM border color is red.
3-4-2. Exit Factory Mode
(1) When OSM MENU is displayed, push "EXIT" SW twice. Otherwise, push "EXIT" SW once.
(2) When "WARNING" is displayed, push "EXIT" SW once.
(3) OSM border color is cyan.
This Menu can be operated by the customer.
This Menu is hidden from the customer, and is used by service personal and
factory.
OSM border color is red.
Power Management function is non-operational.
OSM border color cyan.
When the signal cable is disconnected from the signal generator, Power
Management function operates.
It is not possible to enter MENU (F) by shortcut key.
5-4