Elite REAL E-MOTION Bedienungsanleitung Seite 19

NAME AND LIST OF COMPONENTS
1) RH FIXED BAR
2) RH OSCILLATING BAR
3) RH REAR PLASTIC COVERING
4) REAR AND FRONT EXTERNAL PROFILE
5) REAR ROLLER
6) LH REAR PLASTIC COVERING
7) MIDDLE ROLLER
8) LH FIXED BAR
9) LH OSCILLATING BAR
10) LH WHEEL HOLDER BRACKET
11) WHEEL
12) LH FRONT PLASTIC COVERING
ASSEMBLY
Your Real E-motion roller does not require any
assembly, since this is done entirely at our pro-
duction facility. Each unit is also tested before
being shipped.
SEMPLIFIED GENERAL DIAGRAM
Illustration 1 shows the diagram of the Real
E-motion. The parts in black are supplied in the
Real E-motion box, while the user must provide
the parts in grey.
USE
Before starting to use your Real E-motion it is
necessary to adjust the centre distance of the rol-
lers to make them compatible with the size of your
bicycle frame.
Adjustment must be carried out as follows:
1) Measure the length between the centre of the
wheels of the bicycle you are going to use on the
Real E-motion (Fig.1). For the sake of convenien-
13) FRONT ROLLER
14) RH WHEEL HOLDER BRACKET
15) RH FRONT PLASTIC COVERING
16) DRIVE BELT
17) ELASTIC
18) ELASTIC FIXING PIN
19) POWER ADAPTER
20) ANT KEY
21) CD-ROM
22) 2 DVD ROM
23) INSTRUCTION MANUAL
24) ALLEN KEY
ce this will be called dimension "X".
2) The distance from the middle point between the
two rear rollers to the centre of the Real E-motion's
front roller, which for the sake of convenience will
be called dimension "Y" (Fig.2), must be the same
as or as close as possible to dimension "X" .
The axle of the Real E-motion front roller must be
positioned in the hole in the Real E-motion's
frame, whose measurement given on the gradua-
ted scale is closest to dimension "X" (Fig.3).
ATTENTION: dimension "Y" must be equal to or
slightly greater than "X". The rollers can be adju-
sted to adapt them to bicycles having a distance of
0944-1124 mm (37 to 44 inches).
3) To position the front roller in the correct posi-
tion, remove the 4 lower elastics (Fig.4).
4) Slacken the drive belt by making it come off the
respective front and rear guides (Fig.5 and 6)
5) Undo, but not completely (max. 3-4 complete
turns,) the front support fixing screws (Fig.7 and
8), using the hex key supplied.
6) Repeat the same operation on the opposite side
(Fig.9 and 10).
7) After releasing the mechanism, move the roller
EN
15