7. Use a screw driver to slightly lever up the internal speaker. Then, remove the internal speaker from
the retaining tabs.
Figure 143. Removing the internal speaker
8. Insert the new internal speaker as shown until it is secured by the retaining tabs.
Figure 144. Installing the internal speaker
9. Install the system board. See "System board" on page 173.
Note: Ensure that the internal speaker cable is routed underneath the system board.
10. Connect the cable of the new internal speaker to the internal speaker connector on the system board.
See "Parts on the system board" on page 35.
11. Reinstall the optical-drive bracket. See "Optical-drive bracket" on page 122.
12. Reinstall the direct cooling air baffle. See "Direct cooling air baffle" on page 101.
.
Chapter 9
Installing or replacing hardware
181