Inhaltsverzeichnis
Werbung
a. Record the cable routing and cable connections, and then disconnect all cables from the system
board, the RAID card, and the flex adapter.
b. Press and hold the metal retainer
from the four tabs.
Figure 94. Removing the blind-connect assembly
c. Pull the blind-connect assembly completely out of the chassis and remove the cables through
the routing hole.
Note: Be careful when you pull the cables through the hole.
5. Take the new blind-connect assembly. Insert the cables through the routing hole at the bottom of
the storage drive bay.
146
ThinkStation P510 and P710 Hardware Maintenance Manual
a
, and slide the blind-connect board as shown to release it
Werbung
Inhaltsverzeichnis
