Inhaltsverzeichnis
Werbung
6. Slide the cover presence switch as shown to remove it from the computer chassis.
Figure 55. Removing the cover presence switch
7. Align the two notches in the new cover presence switch with the two tabs on the computer chassis.
Then, push the new cover presence switch inward until it is seated securely between the tabs.
Figure 56. Installing the cover presence switch
8. Connect the cable of the new cover presence switch to the cover presence switch connector on the
system board. See "Parts on the system board" on page 35.
9. Reinstall the optical-drive bracket. See "Optical-drive bracket" on page 122.
10. Reinstall the direct cooling air baffle. See "Direct cooling air baffle" on page 101.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 189.
.
Chapter 9
Installing or replacing hardware
125
Werbung
Inhaltsverzeichnis
