Inhaltsverzeichnis
Werbung
4. If you are replacing a storage drive, flex the sides of the bracket to remove the storage drive from
the bracket.
Figure 65. Removing the storage drive from the type
5. Flex the sides of the bracket and align pins
storage drive. Do not touch the circuit board
Note: Ensure that the circuit board
the bracket.
Figure 66. Installing the storage drive into the type
2
bracket
1
on the bracket with the corresponding holes in the new
3
on the storage drive.
3
faces upward and the connectors
2
bracket
2
face toward the rear of
.
Chapter 9
Installing or replacing hardware
131
Werbung
Inhaltsverzeichnis
