Inhaltsverzeichnis
Werbung
5. Slide the bracket with the new storage drive into the storage drive bay.
Figure 63. Installing the type
6. Connect the signal cable and the power cable to the new storage drive, and then close the handles
on both sides of the bracket.
To install or replace a 3.5-inch storage drive in a type
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 99.
2. Locate the storage drive bay. See "Internal drives" on page 38.
3. Press the pit on the bracket cover, and then grasp the tilted cover to pull the bracket out of the storage
drive bay.
Figure 64. Removing the type
130
ThinkStation P510 and P710 Hardware Maintenance Manual
1
storage drive bracket
2
2
storage drive bracket
bracket, do the following:
Werbung
Inhaltsverzeichnis
