Lenovo ThinkStation P710 Hardwarebedienungsanleitung Seite 127

c. Hold the clip on the retaining bracket and then insert the front Thunderbolt I/O adapter and the
retaining bracket into the flex module as shown until they snap into position.
Figure 49. Installing the front Thunderbolt adapter and the retaining bracket into the flex module
6. Install the front Thunderbolt PCI Express x4 card into the PCI Express 2.0 x4 card slot on the system
board. See "PCI card" on page 149 and "Parts on the system board" on page 35.
7. Connect the cables to the front Thunderbolt I/O adapter.
• Connect the power cable in the flex module to the 4-pin power connector
• Connect the GPIO cable to the connector
• Connect the internal DP-to-DP cable to the DisplayPort connector
• Connect the Mini-SAS cable to the SAS connector
Figure 50. Front Thunderbolt adapter cable connection
b .
a
b
a
c .
d .
c
d
.
Chapter 9 Installing or replacing hardware
.
121