Lenovo ThinkStation P710 Hardwarebedienungsanleitung Seite 113

1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 99.
2. If the flex bay storage enclosure is installed in the computer, disconnect the signal cable and the power
cable from the 2.5-inch storage drive first. Then, remove the flex bay storage enclosure from the front of
the computer. See "Device in the optical-drive bay" on page 102.
3. If you are replacing a 2.5-inch storage drive, do the following:
a. Remove the four screws that secure the storage converter. Take the storage converter together with
the drive out of the flex bay storage enclosure.
Figure 22. Removing the 2.5-inch storage drive and the storage converter from the flex bay storage enclosure
.
Chapter 9 Installing or replacing hardware
107