Inhaltsverzeichnis
Werbung
4. Press the retaining clip
the rear to remove it from the computer chassis.
Figure 52. Removing the optical-drive bracket
To reinstall the optical-drive bracket, do the following:
1. Position the optical-drive bay into the chassis at a relative angle of about 45-degree as shown. Align
the two posts on the top and the bottom of the optical-drive bracket with the notches in the computer
chassis.
Figure 53. Positioning the optical-drive bracket into the chassis
1
on the top of the optical-drive bracket. Then, pivot the bracket outward from
.
Chapter 9
Installing or replacing hardware
123
Werbung
Inhaltsverzeichnis
