Chapter 5.3 Cleaning; Installation - Ugolini Quick-Gel Gebrauchsanweisung

1 TECHNICAL CHARACTERISTICS
Bowl capacity, approx
Evaporator capacity, approx
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Hermetic compressor
Air-cooled condenser
Overload protector
Noise level lower than 70 dB (A)
IMPORTANT
Electrical characteristics: read the data featured on the
data plate of each dispenser; this data plate is situated in
the lower part of the front panel, behind the drip tray. The
serial numbers of appliances (preceded by the symbol #)
are indicated on the frame, at the rear of the appliance,
behind the condenser cover panel. The data specified on
the data plate are always those you should refer to.
The manufacturer reserves the right to amend this manual
without notice.
2 INTRODUCTION
Read this instruction manual carefully to find out all the
characteristics of the dispenser.
As with all mechanical products, this dispenser also requires
cleaning and care. In addition, its correct operation may be
compromised by possible errors made by the operator during
the disassembly and cleaning operations. For this reason, it is
important that the disassembly, cleaning, sanitising and
reassembly procedures - being everyday tasks - are familiar,
without any room for error on the part of the dispenser user.

3 INSTALLATION

1 Take the dispenser out of its packaging, which we
recommend you keep for future requirements.
2 Make sure that the dispenser has not been damaged during
transportation. If this is the case, immediately make a claim
with your carrier.
3 Place the dispenser onto a counter designed to withstand
its weight, including when full.
4 Leave a clearance of at least 15 cm around the whole
dispenser to avoid obstructing the cooling air flow.
5 Check the stability of the appliance and adjust the height of
the feet if necessary. Should the dispenser be supplied with a
series of high feet (100 mm approx.), replace the originals with
these.
6 Before making the electrical connection to the dispenser,
check that the supply mains matches the one specified on the
data plate. Connect the dispenser to a single-phase network,
using an earthed socket as set forth by the applicable
regulations in force. Should you wish to make a fixed
connection to the network, connect the cable to a bipolar wall
switch with a minimum contact opening of 3 mm. Do not use
extensions for the electrical connection of the appliance.
ATTENTION
l 4
Make sure the appliance is earthed correctly; if this is not
the case, this may cause electric shocks to people or
l 2
damage to the dispenser.
cm 26
7 The dispenser is not supplied pre-cleaned and sanitised by
cm 57
the factory. Before use, it must be disassembled, cleaned and
sanitised according to the instructions provided herein in
cm 72

chapter 5.3 CLEANING.

kg 50
kg 55
IMPORTANT
Position the appliance in such a way that the power sup-
ply cable plug is easily accessible.
4 TO OPERATE SAFELY
1 Do not use the dispenser before reading this instruction
manual first.
2 Do not use the dispenser unless it is earthed correctly.
3 Do not use extensions for the electrical connection of the
dispenser.
4 Do not operate the dispenser if the panels are not in place
and secured with screws.
5 Do not obstruct the flow of cooling air; leave a clearance of
at least 15 cm all around the dispenser.
6 Do not insert your fingers or objects into the panel slits or in
the tap orifice.
7 Do not remove parts or panels for cleaning or maintenance
without first making sure the dispenser is disconnected from
the electricity supply.
8 This unit can work at a room temperature range between
+5° and +32°C.
9 Appliance not suitable for installation in areas where jets of
water may be used.
10 Do not use a water jet for cleaning.
11 The appliance must be installed in the upright position.
12 Do not use explosive substances such as spray cans
containing flammable fuel in the vicinity of the appliance.
13 This appliance is intended for professional use and not for
domestic applications and similar.
14 The appliance is not suitable for outdoor use.
15 Do not crush the power supply cable.
16 Do not keep hazardous or toxic substances or liquids in the
vicinity of the appliance.
17 The cover must remain closed at all times.
14