Cleaning And Sanitizing - Ugolini Quick-Gel Gebrauchsanweisung

13)
figure 13
ALARMS
The machine is fitted with a self-diagnosis system. In the event
of a breakdown, the user is notified by the alarm icon on the
display. Press this icon to display the explanatory text relating to
the alarm under way. (see figure 14)
figure 14
5. 2 OPERATION HELPFUL HINTS
The appliance parameters are factory set to guarantee optimum
operation. They must only be changed by the manufacturer, by
his technical support team or other similarly qualified persons, in
order to prevent any risks of malfunctioning.
5. 3 SUGGESTIONS
1 Every dispenser like this one needs to generate heat.
Should the heat generated be excessive, make sure that no
heat sources are situated in the vicinity of the dispenser and,
specifically, near the gridded panels. Also make sure the air
flow is not obstructed by the closeness of walls, boxes or other
items. Leave a clearance of at least 15 cm all around the
dispenser. Also make sure the filter situated beneath the rear
panel is clean.
2 This appliance is only intended for use with confectionery
products.
ATTENTION
Appliance usage is restricted to persons having safety/
hygiene knowledge and practical experience with the
appliance.

5. 4 CLEANING AND SANITIZING

1 Cleaning and washing the appliance are vital to guarantee
perfect preservation of product flavour and maximum efficiency
of your dispenser. The procedures described below must be
considered of a general nature and may vary owing to the
applicable health and safety regulations in force.
2 Before disassembling the dispenser for washing, empty it of
all ice cream mixture. Proceed as follows:
1 on the keyboard, select the WASHING operating mode
2 if necessary wait for the mixture to liquefy
3 place a tub under the tap and empty all the contents of the
upper tank and cylinder
4 remove the cover.
If the cover is fitted with a safety lock, turn the key anti-
clockwise. (see figure 15)
5 fill the upper tank with water and allow the dispenser to ope-
rate in WASHING mode for a few minutes. Then empty out
the whole dispenser.
6 hold down key A to turn off the dispenser
7 turn off the main switch
5. 4. 1 DISASSEMBLY
ATTENTION
Before disassembling any component, always unplug
the appliance from the mains.
1 Remove the upper cover. (see figure 16)
If the cover is fitted with a safety lock, turn the key anti-
clockwise and remove it. (see figure 15)
18
figure 15
figure 16