Assembling Motor - BADU Normblock Multi Originalbetriebsanleitung

Maintenance
8.5.5

Assembling motor

 The motor and pump shafts must not be greasy!
1. Plug the motor shaft end into the shaft (210). The motor shaft
key nut and the slit in the shaft (210) have to be congruent
and lay opposite the slit in the supporter ring (515). See "Fig.
7" on page 40
2. Tighten the hexagon socket screw (914.1).
3. Loosen the hexagon screw (901.3).
4. Pull both lockwashers (931) completely out of the shaft nut.
See "Fig. 8" on page 40
5. Tighten the hexagon screw (901.3).
6. Attach and tighten the nuts (920.5).
Fig. 7
X
Y
210
Fig. 8
Opening SW 34 (BG 100, BG 112)
S
Opening SW 46 (BG 132, BG 160, BG 180)
40 EN
Y
VW61.21.023
Slit in the shaft
Motor shaft key nut
Pump shaft
X
210
800
515
914.1
515 Support ring
800 Motor
Hexagon socket
914.1
screw
04/2019