Installing The Wireless Module - Sirona Cerec AC Connect Umbauanleitung

Sirona Dental Systems GmbH
Instructions for Conversion to CEREC AC CEREC AC Connect
63 43 631 D3492
D3492.092.05.01.02 03.2011
3

Installing the wireless module

1. Fasten the holder for the wireless module to the acquisition unit with
two screws (A).
or
If no fastening holes are present, attach the holder with the sup-
➢
plied Velcro strap.
2. Push the wireless module into the holder.
3. Connect the power cable (B) to the lower connector of the wireless
module and run it along the housing to the PC. Connect the cable to
the supply board of the PC as shown.
4. Connect the LAN cable (C) to the upper connection of the wireless
module and run it along the housing to the PC.
5. Connect the LAN cable to the LAN interface on the PC.
Installing the wireless module
9