Removing The Camera Holder - Sirona Cerec AC Connect Umbauanleitung

Removing the covers

Removing the camera holder

8
2.4
Removing the camera holder
1. Unscrew the camera from the camera cable and remove the camera.
Removing the camera holder
2. Pull the cable (A) of the heater from the board.
NOTICE
Pay attention to the screw threads when removing and re-inserting the
screws. The threads of the middle screw differ from those of the other
screws.
3. Loosen the three screws (B) of the camera holder. Be careful not to
lose the washer of the middle screw.
4. Remove the camera holder from the device sideways.
Instructions for Conversion to CEREC AC CEREC AC Connect
Sirona Dental Systems GmbH
63 43 631 D3492
D3492.092.05.01.02 03.2011