Installing The Covers; Installing The Camera Holder - Sirona Cerec AC Connect Umbauanleitung

Installing the covers

Installing the camera holder

12
5

Installing the covers

5.1
Installing the camera holder
Installing the camera holder
1. Hold the camera holder against the stop at the front and twist in the
rear half until the camera holder is seated flush. The camera cable
has to be inserted through the opening intended for this purpose.
2. Fasten the camera holder securely by tightening the three screws (B).
Use the washer for the middle screw.
3. Connect the cable (A) of the heater to the board.
Instructions for Conversion to CEREC AC CEREC AC Connect
Sirona Dental Systems GmbH
63 43 631 D3492
D3492.092.05.01.02 03.2011