Stopping The Pump; Safety Rules - Agilent Technologies MS40+ Bedienungshandbuch

5 Technical Information

Stopping the Pump

Stopping the Pump

There are no special procedures for switching the pump off; it needs
only to be disconnected from the electric power by means of the
bipolar switch. When the pump is stopped, the anti-suckback de-vice
makes it possible to maintain vacuum in the vessel connected on the
inlet flange of the pump.

Safety Rules

Personnel responsible for pump operation and maintenance must be
well-trained and must be aware of the accident prevention rules. The
accident prevention precautions contained in this section must be
respected at all times during operation and maintenance of the pump
to avoid damage to operators and to the pump. These precautions are
provided in the form of WARNING and CAUTION notes.
WARNING! Operating procedures, technical information and precautions which, if not
respected and/or implemented correctly may cause body harm to operators.
Before connecting the IEC320 mains cable, install the Retention Spring provided
NOTE
with the MS40+. The Retention Spring has to be fastened to IEC320 connector
lateral screws.
Use the Retention Spring to secure the mains cable into the IEC320 socket.
NOTE
Operating procedures, technical information and precautions, which, if not
CAUTION!
respected and/or imple-mented correctly, may cause damage to the pump.
60/90 MS40+ Single Stage Rotary Vane Pumps User Manual / 87-901-008-01 (E)