Displaying The Voltage - Dräger VarioGard Gebrauchsanweisung

Displaying the voltage

This function can be used to query the supply voltage of the individual slaves
in order to check the wiring.
In measurement mode:
u
Press [ ] key.
Enter password (for maintenance or configuration).
u
Press [ ] key to change over to menu mode.
Display:
Use [ q ] or [ l ] key to select the » DISPLAY VOLTAGE « option.
u
Press [ ] key –
the display starts with slave Address 0 (central unit) –
the voltages V and V
min
V and V are the minimum and maximum voltages transmitted since
min max
the last time the function was queried.
Use the [ q ] or [ l ] key to call up all the other slaves.
The battery voltage and emergency power supply voltage can also be
displayed on the central unit.
To quit the function:
u
Press [ ] key to quit the function and display the menu option again.
The voltages V and V
min
are displayed in the second line.
max
are reset.
max
Menu mode
Displaying the voltage
MENU:
MEASUREMENT
MENU:
DISPLAY VOLTAGE
Master and relay
29.10 Vmin 29.90 Vmax
Transmitter
29.10 Vmin 29.90 Vmax
Converter module
29.00 Vmin 29.90 Vmax
Relay module
28.80 Vmin 29.80 Vmax
MENU:
DISPLAY VOLTAGE
0
1
6
7
77