Intended Use; Information In The Event Of An Emergency - ProMinent DULCOTEST CLT 1-mA-2 ppm Montage- Und Betriebsanleitung

Introduction
1.4

Intended Use

NOTICE!
Intended Use
– The sensor should only be used to
measure and regulate concentra‐
tions of chlorite produced as a
reaction product during the disin‐
fection of water using chlorine
dioxide
– All other uses or modifications are
prohibited
– The sensor is not suitable for
checking for the absence of
chlorite
– The presence of reducing agents
may adversely affect measure‐
ment
– The sensor is not a safety compo‐
nent in the sense of DIN EN ISO
13849-1:2008-12. If there is a crit‐
ical process in your measurement
and control circuit, then it is your
responsibility to make sure this
process is safe.
1.5 Information in the event of
an emergency
In the event of an emergency, switch off
n
the controller
If liquid escapes from the continuous flow
n
gauge, close the stopcocks on the inlet
and outlet installed by the customer.
Observe the plant operator's safety infor‐
n
mation before opening the continuous flow
gauge.
12