Intended Use - ProMinent DULCOTEST CDE 2-mA-2 ppm Montage- Und Betriebsanleitung

Initial Overview
Nameplate
Fig. 2: Nameplate on the sensor shaft and
packaging
The nameplate provides information on:
Product group, here DULCOTEST
n
Type, here e.g. CDE 2-mA-0.5 ppm
n
Part number
n
Measured variable, here chlorine dioxide
n
(ClO )
2
Upper measuring range limit in mg/l
n
F. No. = Production batch
n
CE mark
n
The nameplate is located both on the sensor
shaft as well as on the sensor packaging.
Sensor and packaging can be matched to each
other by the label.
1.1

Intended use

The sensor may only be used to determine and
control concentrations of chlorine dioxide (ClO
in water.
Only use the sensor in surfactant-free water or
solutions.
All other uses or modifications are prohibited.
The sensor is not a safety component in the
sense of DIN EN ISO 13849-1:2008-12. If there
is a critical process in your measurement and
control circuit, then it is your responsibility to
make sure this process is safe.
44
®
)
2