Introduction; Certification; Warranty; Limitation Of Warranty - nVent Raychem NGC-20-C-E Installations-, Betriebs- Und Wartungsanleitung

1. INTRODUCTION

Please read all instructional literature carefully and thoroughly before starting. Refer to the inside front cover for the listing of Liabilities
and Warranties.
NOTICE: The information contained in this document is subject to change without notice.
Please read these Operating Instructions before Commissioning the instrument. Keep the operating instructions in a place which is
accessible to all users at all times. Please assist us to improve these operating instructions, where necessary. We are always grateful for
your suggestions.
Should any difficulties arise during start-up, you are asked not to carry out any unauthorized manipulations on the instrument as this
could affect your warranty rights! Please contact the nearest nVent subsidiary or the head office.
If any servicing is required, the instrument must be returned to the head office.

1.1 Certification

nVent certifies that this product met its published specifications at the time of shipment from the Factory.

1.2 Warranty

This nVent product is warranted against defects in material and workmanship for a period of 12 months from the date of installation or
30 months maximum from the date of shipment, whichever occurs first. During the warranty period, nVent will, at its option, either repair
or replace products that prove to be defective.
For warranty service or repair, this product must be returned to a service facility designated by nVent. The Buyer shall prepay shipping
charges to nVent and nVent shall pay shipping charges to return the product to the Buyer. However, the Buyer shall pay all shipping
charges, duties, and taxes for products returned to nVent from another country.
nVent warrants that the software and firmware designated by nVent for use with a product will execute its programming instructions
properly when installed on that product. nVent does not warrant that the operation of the hardware, or software, or firmware will be
uninterrupted or error-free.

1.3 Limitation of warranty

The foregoing warranty shall not apply to defects resulting from improper or inadequate maintenance by the Buyer, Buyer-supplied
software or interfacing, unauthorized modification or misuse, operation outside of the specifications for the product, or improper
installation.
NO OTHER WARRANTY IS EXPRESSED OR IMPLIED. NVENT DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE.

1.4 Exclusive remedies

THE REMEDIES PROVIDED HEREIN ARE THE BUYER'S SOLE AND EXCLUSIVE REMEDIES. NVENT SHALL NOT BE LIABLE FOR ANY
DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, WHETHER BASED ON CONTRACT, TORT, OR ANY OTHER
LEGAL THEORY.

1.5 Statement of compliance

This equipment has been tested and found to comply with the low voltage directive 2006/95/EC and the electromagnetic compatibility
directive 2004/108/EC. These limits are defined to provide reasonable protection against harmful interference in a residential
installation (technical data mentions industrial application). This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4 | nVent.com