Service, Repair - MICRO-EPSILON optoCONTROL 1201 Betriebsanleitung

Warranty
8.
All components of the device have been checked and tested for perfect function in the factory.
In the unlikely event that errors should occur despite our thorough quality control, this should be reported
immediately to MICRO-EPSILON Eltrotec GmbH. The warranty period lasts 12 months following the day of
shipment. Defective parts, except wear parts, will be repaired or replaced free of charge within this period if
you return the device free of cost to MICRO-EPSILON Eltrotec GmbH.
This warranty does not apply to damage resulting from abuse of the equipment and devices, from forceful
handling or installation of the devices or from repair or modifications performed by third parties. No other
claims, except as warranted, are accepted. The terms of the purchasing contract apply in full.
MICRO-EPSILON Eltrotec GmbH will specifically not be responsible for eventual consequential damages.
MICRO-EPSILON Eltrotec GmbH always strives to supply the customers with the finest and most advanced
equipment. Development and refinement is therefore performed continuously and the right to design chang-
es without prior notice is accordingly reserved.
For translations in other languages, the data and statements in the German language operation manual are
to be taken as authoritative.
9.
In the event of a defect in the controller, light sour-
ce, receiver or the sensor cable, the complete sys-
tem must be sent back for repair or replacement.
In the case of faults the cause of which is not
clearly identifiable, the entire measuring system
must be sent back to:
optoCONTROL 1200/1201
Warranty

Service, Repair

MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Germany
Tel. +49 (0) 7161 / 98872-300
Fax +49 (0) 7161 / 98872-303
eltrotec@micro-epsilon.de
www.micro-epsilon.com
Page 55