Technical Specifications Of Components - Mhouse GDX Serie Anweisungen Und Hinweise Für Die Installation Und Die Bedienung

WARNINGS:
– The product GDX... is produced by Nice S.p.a. (TV) I. Mhouse is a commercial trademark owned by Nice S.p.a.
– All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C).
– Nice S.p.a. reserves the right to apply modifications to the product at any time when deemed necessary, while maintaining the same functionalities and intended use.
DESCRIPTION
Technology adopted
Power supply
Maximum start-up torque
Nominal torque
Nominal thrust
Maximum power
Movement speed
Maximum continuous operation time
Maximum cycle frequency
Ambient operating temperature
Dimensions
Weight
Insulation class
Emergency power supply
Courtesy light
STOP Input
STEP-STEP Input
PHOTO input
Radio receiver
Programmable functions
Functions in self-learning mode
Use in particularly acid or saline
potentially explosive atmospheres
Protection class
Estimated durability ( )
*
( ) Note – The estimated product durability ranges from 40.000 to
*
80.000 manoeuvre cycles. To calculate the probable durability of your
automation proceed as follows:
a) – evaluate the conditions of use and force levels involved on your sys-
tem, for example:
• the weight and length of the garage door;
• perfect balancing of the garage door;
• maintenance conditions of the garage door hinges;
• type of leaf; Solid or with many openings;
• the presence of strong winds;
• frequency of automation use.
b) – from these values, obtain a value expressed as a percentage which,
in general, defines the greatest or smallest degree of automation wear.
c) – on the graph alongside, locate the estimated percentage (at point
"b") and read the corresponding number of manoeuvre cycles.
24 – English
TECHNICAL SPECIFICATIONS OF PRODUCT COMPONENTS
GEARMOTORS GDX01 - GDX02
DATA
24 V motor
230 Vac 50/60 Hz
12 Nm
6.3 Nm
500 N
200 W
0.07 ÷ 0.13 m/s
4 minutes
30 per day (10 in 1 hour)
-20° C ÷ +50° C
305 x 109 h x 130 (mm)
4 kg
1
2 batteries, 12V / 0.8Ah (only for GDXP - GDXPR)
12 V / 10 W fitting BA15
For normally open, normally closed or constant resistance 8,2 KΩ contacts;
in self-learning (a variation with respect to the memorised status causes the command "STOP").
For normally open contacts
For safety devices with normally closed contacts
Built-in
4 programmable functions (see paragraph 6.3) Self learning of type of STOP device (NO contact,
NC contact or 8,2 KΩ resistance)
Self-learning of door opening and closing positions and calculation of deceleration and
partial open points.
No
IP 40 use indoors or in protected environments
From 40.000 to 80.000 manoeuvre cycles
100 %
75 %
50 %
25 %
0 %