Installation Instructions - Truma Combi D 6 Einbauanweisung

Installation instructions

The installation and repair of the appliance is only to be
carried out by an expert. Read the installation instructions
carefully prior to starting work and observe the instructions!
Non-compliance with installation instructions or
incorrect installation can result in endangerment
of persons and property.
Please pay attention to the ESD regulations!
Intended use
The Combi D diesel heater is a warm-air heater with integrated
hot water boiler (10 litre volume). This unit was designed for
installation in motor homes and caravans.
An additional altitude kit (part no. 34610-01) is required for long
periods of heater operation at altitudes of 1500 to 2750 m.
Approval
The heater is approved for installation in passenger vehicles
(class M1 motor homes) with no more than 8 seats excluding
the driver's seat, and for trailers (class O caravans).
Installation inside busses and vehicles (vehicle classes M2 and
M3) is not permitted.
The applicable regulations must be complied with when the
equipment is being installed in special vehicles and vehicles
for transporting hazardous goods.
Other forms of use are also possible after consultation with
Truma.
The year when the equipment was first taken into oper-
ation must be indicated with a check on the type plate.
Declaration of conformity
The device satisfies the requirements of the following
EC Directives:
– Heating Equipment Directive 2001/56/EC, 2004/78/EC,
2006/119/EC
Type approval number e1 00 0232
– Noise Suppression in Vehicles 2004/104/EC, 2005/83/EC,
2006/28/EC
Type approval number e1 03 5277
– End-of-Life Vehicle Directive 2000/53/EC
– Drinking Water Directive 98/83/EEC
The device satisfies the requirements of the following UN ECE
regulations:
– Heating systems in UN ECE R122 vehicles
Type approval number E1 122R-000232
– Noise Suppression in Vehicles UN ECE R10
Type approval number E1 10R-035277
Regulations
Guarantee claims, warranty claims and acceptance of liability
will be ruled out in the event of the following:
– modifications to the unit (including accessories),
– modifications to the exhaust duct and the cowl,
– failure to use original Truma parts as replacement parts and
accessories,
– failure to follow the installation and operating instructions.
It also becomes illegal to use the appliance, and in some
countries this even makes it illegal to use the vehicle.
Installation instructions for vehicles
Installation in vehicles must be in line with the regulations of
the respective country in which it is used. The national legisla-
tion and regulations must be observed.
The relevant employer's liability insurance association accident
prevention regulations must be observed in Germany for vehi-
cles used for commercial purposes.
In other countries, the relevant regulations must be observed.
More information on the regulations in the relevant destina-
tion countries can be requested from our foreign representa-
tives (see Truma Service Booklet or www.truma.com).
Choice of location
The unit and its exhaust duct must always be installed so that
they are easy to access at all times for service work (e.g. fuel
and water connection via a service flap, furniture door etc.)
and are easy to remove and install.
The distance between the unit and surrounding furniture items
or vehicle components must be at least 10 mm at all sides
(5 mm at the water connection side).
The scope of delivery includes a second type plate (duplicate)
with removable bar code.
If the type plate on the heater is not visible after the heater has
been installed, the second type plate (duplicate) must be af-
fixed to the unit in a clearly visible location.
The duplicate must only be used in conjunction with the
original.
Original
Duplicate
13