Scheppach DP5000 Originalbetriebsanleitung Seite 18

Never operate the machine on slopes where angle is over
20°.
When moving over a slope, whether moving forward or
in reverse, always make certain that the weight is even-
ly balanced. Always move in directions parallel with the
slope (up or down).
To avoid danger, do not shift gears on slopes.
When tipping the load from a dumper, the centre of gra-
vity will change continuously and the ground conditions
will be essential for the stability of the machine. There
are special hazards for dumpers working on soft ground
and when the load is sticking to body e.g. wet clay.
Contents supplied, Fig. 1
The all terrain minitransporter comes partially
assembled and is shipped in carefully packed
package. After all the parts have been removed
from the package, you should have:
1. Main Frame
2. Box
3. Operator's Manual
4. Hardware Bag, including
Assembly, Fig. 2
Following the assembly directions below, you will assem-
ble the machine in a few minutes.
Position the bottom panel inside the mounting bracket.
Align the holes with the mounting bracket. Insert a bolt
through holes and secure each side with a flat washer
and a nut.
Engine oil
m Oil has been drained for shipping. Failure to fill engine
sump with oil before starting engine will result in
permanent damage and will void
engine warranty.
Fill with engine oil according to the maintenance sche-
dule.
Features and Controls Fig.3-4
1. Throttle Control
2. Engine Switch
3. Right Steering Lever
4. Clutch Control Lever
5. Left Steering Lever
6. Tipping Handle
7. Gear Selection Lever
8. Dump Box
9. Gearbox
10. Track
Engine switch
The engine switch enables and disables the ignition sys-
tem.
The engine switch must be in the ON position for the
engine to run.
Turning the engine switch to the OFF position stops the
engine.
Clutch control lever
Squeeze the control lever, clutch engaged. Release the
lever, clutch disengaged.
Throttle control
It controls engine speed. Put the throttle control on low
speed (L) or high speed (H) or an intermediary position
between L and H to increase or decrease the speed of
engine.
Left steering lever
Operate the lever to turn left.
Right steering lever
Operate the lever to turn right
Gear selection lever
It controls forward or reverse movements of the machine.
Tipping handle
Pull the locking plate to the direction A with the left
hand and unlock the tipping handle.
To raise the dump box, pull the tipping handle up to the
direction B with the right hand. The hydraulic system
operates, raising the dump box by hydraulic cylinder.
When the dump box is raised to the expected positi-
on, pull the tipping handle back to its original position
and lock it with the locking plate securely, otherwise the
dump box will reach its maximum.
To lower the dump box, pull the tipping handle down to
the direction C with the right hand. The hydraulic system
operates, lowering the dump box by hydraulic cylinder.
When the dump box is lowered to the original position,
pull the tipping handle back to its original position and
lock it with the locking plate securely.
Let the lever go in time when the transport tray is in the
end positions. Otherwise, you risk overloading of the hy-
draulic system.
Motor
Engine components Figure 7-8
1. Throttle
2. Exhaust
3. Spark
4. Air Filter
5. Petcock
6. Choke lever
7. Reversiestarter
8. Recoil
9. Ignition switch
10. Gas cap
11. Fuel tank
12. Oil drain plug
13. Oil filler / dipstick
15