Roller-Scraper Plates; Gearshift - maschio ORSO RAPIDO Gebrauch Und Wartung

ENGLISH
1
fi g.82

4.13 ROLLER-SCRAPER PLATES

The soil scraper has the scraper plates (1 fi g.82) made of wearproof
material to clean caked soil from the roller.
They are installed on shaped supports fi xed to the rear bar of the
roller.
Correct assembly is achieved by mounting the scraper plates on
the soil scraper, and tightening the bolt (1 fi g.83) to fi x the plate to
the desired distance from the roller.
For rubber rollers the recommended distance between the scraper
plate and the roller is 7/10 mm, for other rollers it is 2/3 mm (fi g.84).
CAUTION
It is advisable to adjust the roller scraper plates during the
fi rst 100-150 m of work, nearing them gradually to the roller
to exercise a perfect cleaning operation.

4.14 GEARSHIFT

The machine is equipped with central multi-speed gearbox (1
fi g.52). A variety of rotation speeds of the rotor can be obtained
so that the needs of the operator can be better met.
It is very useful for land which is uneven in that it makes rotary hoe-
ing easy and at the same time allows the tractor to be maintained
at a constant speed.
To change tiller speed you must:
1) Remove the rear grid of the gearbox by unscrewing the fi xing
bolts.(1-2-3 fi g.85)
2) Remove the fan by unscrewing the fi xing bolts (4-5 fi g.86).
2) Remove the carter by unscrewing the fi xing bolts (6-7-8 fi g.87).
7
6
fi g.87
78 - EN
USE AND MAINTENANCE
8
fi g.83
fi g.84
1
fi g.85
fi g.86
1
Distanza consigliata tra rullo e
*
piastrina ( = rullo gommato).
Distance between roller and
*
scraper plate ( = rubber roller).
D i s t a n c e e n t r e l e r o u l e a u
*
et la plaque ( = rouleau
.
caoutchoutè)
Abstand zwischen Walze und
*
Platte ( = Gummiwalze).
Distancia entre el rodillo y la
*
placa ( = rodillo engomado ).
2
3
4
5
cod. F07011388