Two-Position Roller (Brava); Internal Roller (Brava Large); Optional Accessories - maschio BRAVA LARGE Gebrauch Und Wartung

ITALIANO ENGLISH

4.13 TWO-POSITION ROLLER (BRAVA)

The machine has a rear roller (fi g.33) with two positions: exter-
nal and internal.
Internal assembly
The roller can be adjusted internally in three positions: High
in holes (1-A fi g.33); Medium in holes (2-B fi g.33); Low in
holes (3-C fi g.33).
With the internal roller installed, the mud scraper (C Fig. 25)
should no longer be necessary, since the actual tools keep the
components clean as they turn.
The internal position is recommended to cut grass, since the
cutting height is much more even and less stressing for the
machine.
External assembly
The roller can be regulated in three different positions High
in holes (4-D fi g.33); Medium in holes (4-E fi g.33); Low in
holes (4-F fi g.33).
The adjustments are made with the tractor at a standstill, the
driveline detached and the machine blocked.
Fully unscrew the screws right and left, move the roller until
the required holes have been centered, replace the screws
and fi xing the nuts.
When work is carried out with the external roller, the position
of the mud scraper with which it is equipped can also be re-
gulated by hand
.

4.14 INTERNAL ROLLER (BRAVA LARGE)

The machine has a rear roller, only in internal position. This
can be adjusted on 3 different positions (fi g.34).
- If it's fi xed through the holes (A) the roller is in the upper
position. (lower working position)
- If it's fi xed through the holes (B), the roller is in the medium
position.
- If it's fi xed through the holes (C), the roller is in the lower
position. (upper working position)

4.15 OPTIONAL ACCESSORIES

ATTENTION
All maintenance work, adjustments and preparation for
operation, must be carried out with the power take-off of
the tractor disconnected, the machine on the ground on
its supporting feet, the tractor not running, the wheels
blocked and the key turned off.
VERSIONE CON SPOSTAMENTO LATERALE
B
A
fi g.37
58 - EN
USE AND MAINTENANCE
SIDE OFFSET VERSION
BRAVA
1
2
3
fi g.33
BRAVA LARGE
A
B
C
fi g.34
1
2
3
fi g.35
VERSIONE FISSA
FIXED VERSION
A
B
fi g.36
D
A
E
B
F
C
4
A
B
C
1
2
3
Ruota con castello
in posizione laterale
Front wheel in case of third
point hitch in side position
cod. F07021035