Work Depth; Roller Adjustment Standard Version - maschio ORSO RAPIDO Gebrauch Und Wartung

ENGLISH

4.6 WORK DEPTH

Work depth adjustment of the machine is established by the posi-
tion of the levelling roller.
4.7 ROLLER ADJUSTMENT STANDARD
VERSION
The rollers can be adjusted in the following ways:
Hydraulic
The machine has 2 hydraulic cylinders (accessories available on
request, 1 fi g.57).
After having hitched it to the tractor, connect the hydraulic pipes to
this latter so as to operate the roller regulating cylinders. The opera-
tor can make the most suitable adjustments from inside the tractor.
The hydraulic pipes have recognition stickers (fi g.56) showing:
1) Rear roller lowering.
2) Rear roller lifting.
The two cylinders also have an automatic blocking valve (2 fi g.57).
WARNING
The rollers can only be hydraulically regulated when the
harrow is used alone. Only pin adjustment is possible when
it is used in combination with the Seed Drill (see «with pins»
description).
By pins
This type of adjustment allows you to work in two distinct ways.
1) Fixed tilling depth:
After having established the most suitable tilling depth, set the
pins (1 e 2 fi g.58) in the holes immediately above and below
the roller connecting arm (3 fi g.58). This allows the knives of
the implement to dig into the soil and work it at a constant depth
maintained by the position of the pins, which guarantee the fi xed
roller setting.
2) Variable tilling depth (swinging):
Unlike the previous method, the pin is either not needed (2
fi g.59) or can be set in the highest holes, so as to allow the arm
to swing to a certain extent (3 fi g.59).
As the arm can move (3 fi g.59), the machine can ride over any
obstructions encountered during the tillage operations without
the roller being damaged, as the actual arm moves within the
swinging range established by the positions of the pin (1 fi g.59),
since it is no longer blocked by these latter.
Moreover, the advantage of «variable depth» tillage is that it
obtains a more or less uniform soil working level both at the
beginning and end, since the implement digs into the soil at the
beginning as gradually as it raises at the end.
Mechanical
(ONLY FOR STD. VERSION)
The mechanical adjustment of the roller is carried out by means
of 2 jacks ( 1 Fig.57).
This modality is specifi c for Standard Power Harrows.
72 - EN
USE AND MAINTENANCE
fi g.57
2
1
1 3
2
2 1 3
1
cod. F07011388
fi g.58
fi g.59
fi g.60