Stability Of The Equipment And Tractor During Transport - maschio ORSO RAPIDO Gebrauch Und Wartung

4.3 STABILITY OF THE EQUIPMENT AND
TRACTOR DURING TRANSPORT
When a equipment is coupled to a tractor, so becoming an inte-
gral part of it for the purposes of road travel, the stability of the
equipment-tractor complex may change and cause driving or
operating diffi culties (rearing up or side-slipping of the tractor).
The condition of equilibrium can be restored by placing a suffi cient
number of ballasts on the front of the tractor so that the weights on
the two tractor axles are distributed suffi ciently evenly.
To work in safety the instructions given in the highway code should
be followed; these prescribe that at least 20% of the weight of
the tractor alone should be borne by the front axle and that the
weight on the arms of the hoist should not be more than 30% of
the weight of the tractor itself. These factors are summarized in
the following formulas:
Z > [M x (s1+s2)]-(0.2 x T x i)
The symbols have the following meanings (please see
for reference):
M (Kg) Mass weighing on arms off hoist with full load (weight +
mass, see cap. 1.3 Identifi cation).
T (Kg) Mass of tractor.
Z (Kg) Total mass of ballast.
i (m) Tractor wheelbase, that is, the horizontal distance between
the tractor axles.
d (m) Horizontal distance between the centre of gravity of the
ballast and the front axle of the tractor.
s1 (m) Horizontal distance between the inferior point of attach-
ment of the equipment and the posterior axle of the tractor
(equipment supported to the ground).
s2 (m) Horizontal distance between the barycentre of the
equipment and the inferior point of attachment of the
equipment (equipment supported to the ground).
The amount of ballast that should be applied according to the
formula is the minimum required for circulation on the road. If for
reasons of tractor performance or to improve the set-up of the
planting unit during operation it is thought necessary to raise these
values, please refer to the registration document of the tractor to
check its limits.
When the formula for calculating the ballast gives a negative result
it will not be necessary to add any weight. In any case, as long as
the limits of the tractor are respected, a suitable quantity of weights
may be applied in order to ensure greater stability during travel.
Check that the tractor tyres are suitable for the load.
cod. F07011388
USE AND MAINTENANCE
(d+i)
fi g.54-fi g.55
Macchina in manovra nel campo
fi g.54
Machine manoeuvring in the fi eld
Machine en manœuvre sur champ
Maschine im Manöver auf dem Feld
Máquina en maniobra en el campo
Z
T
0,2
d i
Macchina con attacco e seminatrice a sbalzo in manovra nel campo
Machine with hitch and overhanging seed drill manoeuvring in the fi eld
Machine avec attelage et semoir déporté en manœuvre sur champ
schine mit Kupplung und überstehender Drillmaschine im Manöver auf dem F
Máquina con enganche y sembradora saliente en maniobra en el campo
Z
T
0,2
d i
fi g.55
ENGLISH
M
S1 S2
S2 (700 mm)
M
S1 S2
S2 (1800 mm)
EN - 69