Cable Routing Diagram - Yamaha WR250F Fahrer- Und Wartungshandbuch

EC240000

CABLE ROUTING DIAGRAM

1 Hose guide
2 Brake hose
3 Voltage regulator
4 Light switch lead
5 Fuel tank breather hose
6 Engine stop switch lead
7 Clamp
8 Oil tank breather hose
9 Sub-wire harness
0 Taillight lead
A Throttle position sensor lead
B Neutral switch lead
C Oil hose
D Cylinder head breather hose
E CDI magneto lead
F Clutch cable
G Cable guide
H Carburetor breather hose
CABLE ROUTING DIAGRAM
I Carburetor overflow hose
J Coolant reservoir breather hose
K Decompression cable
L Ground lead
M Ignition coil lead
N CDI unit lead
O Voltage regulator lead
Å Pass the fuel tank breather hose
behind handlebar, then insert it
into the steering stem hole.
ı Pass the decompression cable,
engine stop switch lead and light
switch lead under where the oil
hose is attached.
Ç Pass the voltage regulator lead,
engine stop switch lead and light
switch lead over the radiator
hose.
2 - 19
SPEC
Î Fasten the engine stop switch
lead, light switch lead and igni-
tion coil lead of the sub-wire har-
ness.
‰ Fasten the sub-wire harness
and engine stop switch lead.
Ï Pass the cylinder head breather
hose along the right side of the
oil tank breather hose.
Ì Fasten the sub-wire harness
and light switch lead in front of
the upper engine brackets.
Ó Fasten the sub-wire harness.
È Pass
the sub-wire
between the upper
brackets.
Ô Fasten the sub-wire harness.
 Fasten the throttle position sen-
sor lead.
harness
engine