Yamaha WR250F Fahrer- Und Wartungshandbuch Seite 560

HANDLEBAR
8. Install:
Brake master cylinder 1
G
Brake master cylinder bracket 2
G
Bolt (brake master cylinder bracket) 3
G
NOTE:
Install the bracket so that the arrow mark a
G
faces upward.
First tighten the bolt on the upper side of the
G
brake master cylinder bracket, and then
tighten the bolt on the lower side.
9. Install:
Light switch 1
G
10. Install:
Engine stop switch 1
G
Clutch lever holder 2
G
Bolt (clutch lever holder) 3
G
Decompression lever holder 4
G
Bolt (decompression lever holder) 5
G
Clamp 6
G
NOTE:
The engine stop switch, clutch lever holder,
G
decompression lever holder and clamp
should be installed according to the dimen-
sions shown.
Pass the engine stop switch lead in the mid-
G
dle of the clutch holder.
5 - 45
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)
2 Nm (0.2 m · kg, 1.4 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)