Yamaha WR250F Fahrer- Und Wartungshandbuch Seite 450

CRANKCASE AND CRANKSHAFT
a
4
REMOVAL POINTS
Crankcase
1. Separate:
Right crankcase
G
Left crankcase
G
Separation steps:
Remove the crankcase bolts 1, hose
G
guide 2 and clutch cable holder 3.
NOTE:
Loosen each bolt 1/4 of a turn at a time and
after all the bolts are loosened, remove
them.
Remove the right crankcase 4.
G
NOTE:
Place the crankcase with its left side
G
downward and split it by inserting a screw-
driver tip into the splitting slit a in the
crankcase.
Lift the right crankcase horizontally while
G
lightly patting the case splitting slit and
engine mounting boss using a soft ham-
mer, and leave the crankshaft and trans-
mission with the left crankcase.
CAUTION:
Use soft hammer to tap on the case half.
Tap only on reinforced portions of case.
Do not tap on gasket mating surface.
Work slowly and carefully. Make sure the
case halves separate evenly. If one end
"hangs up", take pressure off the push
screw, realign, and start over. If the
cases do not separate, check for a
remaining case screw or fitting. Do not
force.
Remove the dowel pins and O-ring.
G
4 - 91
ENG