Throttle Cable Adjustment - Yamaha WR250F Fahrer- Und Wartungshandbuch

THROTTLE CABLE ADJUSTMENT

2
THROTTLE CABLE ADJUSTMENT
1. Check:
2. Adjust:
Throttle grip free play adjustment steps:
Remove the throttle cable cap 1 and
G
1
throttle cable cover 2.
NOTE:
Before adjusting the throttle cable free
G
play, the engine idle speed should be
adjusted.
When the motorcycle is accelerating,
G
throttle cable #1 3 is pulled and throttle
cable #2 4 is pushed.
1st step:
Loosen the locknuts 5 on throttle cable
G
#2.
Adjust the free play by changing their
G
tightening position.
2nd step:
Loosen the locknuts 6 on throttle cable
G
#1.
Adjust the free play by changing their
G
tightening position.
Tighten the locknuts.
G
After adjusting, turn the handlebar to
right and left and make sure that the
engine idling does not run faster.
Install the throttle cable cover and throttle
G
cable cap.
3 - 10
Throttle grip free play a
G
Out of specification → Adjust.
Throttle grip free play a:
3 ~ 5 mm (0.12 ~ 0.20 in)
Throttle grip free play
G
WARNING
Throttle cable cover:
4 Nm (0.4 m • kg, 2.9 ft • lb)
INSP
ADJ