Cleaning And Maintenance Warranty And Service Information; Warranty Conditions; Extent Of Warranty - Parkside PDWE 8 A1 Bedienungs- Und Sicherheitshinweise

... / Cleaning and maintenance / Warranty and service information
of oil.
The integrated sight window permits continuous
„ z
overview of the filtered compressed air.
To top up oil, turn the screw (B) down with
„ z
a suitable socket wrench. Fill the tank with a
matching hopper and tighten the screw again
with the wrench.
Troubleshooting
Faults Causes
The lubrication The oil pas-
is not sufficient sage screw it
tightened too
far in direction
("–").
The com-
pressed air
volume is too
low, i.e. below
the minimum
fill level.
The operating The pressure
pressure of the controller
compressed is tightened
air is too low. too far
(see above).
Cleaning and maintenance
Note:
The pneumatic maintenance unit must be
regularly serviced and overhauled for
proper function and for compliance with the safety
requirements. Improper and wrong operation may
cause failures and damage to the device.
Never use any sharp and/or scraping cleaning
„ z
agents or solvents. They may damage the plas-
tic parts of the pneumatic maintenance unit.
Make sure that no water can enter inside the
„ z
oiler.
Ensure that the housing and the inside of the
„ z
pneumatic maintenance unit remains dust- and
dirt-free. For this, regularly rub the pneumatic
maintenance unit with a clean cloth.
„ z
„ z
Warranty and service
Solution
information
Increase
lubrication
Warranty from Creative Marketing
(see above).
Consulting GmbH
Dear Customer,
Pour more oil The warranty for this device is 3 years from the
into the oil date of purchase. In the event of product defects,
tank. Observe you have legal rights against the retailer of this
the maximum product. Your statutory rights are not affected in
fill level. any way by our warranty conditions, which are
described below.
Increase the
pressure
z z
(see above).
The warranty period begins on the date of pur-
chase. Please retain the original sales receipt. This
document is required as your proof of purchase.
Should this product show any defect in materials
or manufacture within 3 years from the date of
purchase, we will repair or replace it – at our
discretion – free of charge. To claim against this
warranty, you must present the defective device
and your purchase receipt within the 3-year period,
and include a brief written description of the nature
of the defect and the date it occurred. If the defect
is covered by our warranty, we will repair and
return your product or send you a replacement.
The original warranty period is not extended when
a device is repair or replaced.
z z
The device has been manufactured according to
strict quality guidelines and meticulously examined
Clean the pneumatic maintenance unit and the
connections with a moist cloth at regular intervals.
Drain the pneumatic maintenance unit's tank
at regular intervals. For this, press in the metal
pin at the bottom and let the condensate drain.
Note that the pneumatic maintenance unit must
be depressurised for safety.

Warranty conditions

Extent of warranty

Table of contents
GB/IE/NI 23