Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Cleaning And Maintenance; Warranty And Service Information; Warranty Conditions - Parkside PDWE 8 A2 Originalbetriebsanleitung

Druckluft-wartungseinheit
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Troubleshooting / Cleaning and maintenance / Warranty and service ...
z Troubleshooting
Faults
Causes
The lubrica-
The oil pas-
tion is not
sage screw
sufficient
it tight-
7
ened too far
in direction
("–").
The com-
pressed air
volume is
too low, i.e.
below the
minimum fill
level.
The operat-
The pressure
ing pressure
controller
of the com-
is tightened
pressed air
too far
is too low.
(see above).
z Cleaning and maintenance
Note:
The pneumatic maintenance unit
must be regularly serviced and over-
hauled for proper function and for compli-
ance with the safety requirements. Improper
and wrong operation may cause failures
and damage to the device.
Never use any sharp and/or scraping
cleaning agents or solvents. They may
damage the plastic parts of the pneumat-
ic maintenance unit.
Make sure that no water can enter inside
the oiler.
Ensure that the housing and the inside of
the pneumatic maintenance unit remains
dust- and dirt-free. For this, regularly rub
the pneumatic maintenance unit with a
clean cloth.
Clean the pneumatic maintenance unit
24
GB/IE
Solution
Increase
lubrication
(see above).
Pour more
oil into the
oil tank
.
11
Observe the
maximum fill
level.
Increase the
pressure
3
(see above).
and the connections with a moist cloth at
regular intervals.
Drain the pneumatic maintenance unit's
tank at regular intervals. For this, press in
the metal pin
12
condensate drain (see Fig. G). Note that
the pneumatic maintenance unit must be
depressurised for safety.
z Warranty and service infor-
mation
Warranty from Creative Marketing
Consulting GmbH
Dear Customer, The warranty for this device
is 3 years from the date of purchase. In the
event of product defects, you have legal
rights against the retailer of this product.
Your statutory rights are not affected in any
way by our warranty conditions, which are
described below.
z Warranty conditions
The warranty period begins on the date of
purchase. Please retain the original sales
receipt. This document is required as your
proof of purchase. Should this product show
any defect in materials or manufacture within
3 years from the date of purchase, we will
repair or replace it – at our discretion – free
of charge. To claim against this warranty,
you must present the defective device and
your purchase receipt within the 3-year pe-
riod, and include a brief written description
of the nature of the defect and the date it
occurred. If the defect is covered by our war-
ranty, we will repair and return your product
or send you a replacement.
The original warranty period is not extended
when a device is repair or replaced.
at the bottom and let the

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis